Stair Riser User Guide
How to use our Stair Riser Strips
You will need:
- A general purpose kitchen cleaner & a sponge
- A pencil
- A utility knife or pair of scissors
- A soft cloth
 |
 |
|
Apply to a clean, dry and non-porous surface. Painted surfaces must be a satin or gloss paint as matte paint repels the adhesive. |
Mark the center of a strip and your stair riser with a pencil. Peel back half of the backing paper to the center mark, align it to the center of the riser & butt the top edge into to stair tread. |
 |
 |
|
Once the strip is in attached use a cloth to smooth it down & continue until the entire strip is in place.Try not to trap any air bubbles in the vinyl. Press over the edges to ensure a firm adhesion. Butt the vinyl to the staircase edge as best you can. Trim edges with a cutter for perfect fit. |
Repeat steps 2 & 3 until all the risers are in place & the pattern flows uniformly. Leave the new surface to cure 24 hours before returning to normal activity. Do not wash or moisten the strips until 24 hours have past. |